GET Engineering 10072501 NTDS / PCI Parallel Interface Adapter
GET Engineering Legacy / Obsolete Test Equipment. Resolution: ** 10 µs or 1 ms increments with command and inte, Resolution: ** 125 ns on individual input words.
- Model
- GET Engineering 10072501
- Calibration
- Available on request
- Price · starting from
- $1,850
- Status
- In stock
- RFQ ref
- 10072501
This unit
The GET Engineering 10072501 is a NTDS/PCI Parallel Interface Adapter that enables high-speed parallel data transfer between NTDS-protocol devices and PCI-based computer systems. Designed for military and industrial applications, this half-length adapter card delivers full NTDS data rates through software-configurable protocols, dual data paths, and independent I/O channels supporting simultaneous full-duplex operations.
Technical Specifications
Protocol Compliance: MIL-STD-1397C compliant with support for Slow, Fast, ANEW, and High Speed ANEW parallel protocols
Bus Interface: PCI slot; compatible with x1, x2, x4, x8, or x16 PCIe slots on related PCIe models
Data Path: Software-selectable 16-bit or 32-bit configurations
Form Factor: Single half-length PCI short card, 4.2" × 6.875"
NTDS Connector: Rear-panel 112-pin high-density connector (Berg. 50295-5112E or 160-pin SEARAY/MIL-DTL-32139 on PCIe variants)
Operational Modes: Software-selectable Computer, Peripheral, Intercomputer, or Interperipheral channel emulation
Time-out Resolution: 10 µs or 1 ms increments with command and inter-word time-out timers
Timestamp Resolution: 125 ns on individual input words; software-selectable
Key Features
Full-duplex simultaneous input and output with hardware-independent channels
Short-circuit protection on all outputs with fail-safe input operation and tristate output capability
Plug & Play configuration - no jumpers or switches required; NTDS type software-selectable
Burst and interrupt-driven transfer modes for full NTDS data rate support
On-board time-stamp generator for passive and active communications
Extensive built-in tests (BIT) with internal loopback capability without cable disconnection
High Mean Time Between Failure (MTBF) via high-scale integration, programmable gate arrays, and surface-mount technology
Passive tap application support
Typical Applications
Military and defense systems requiring MIL-STD-1397C parallel communications
Industrial real-time data acquisition and control systems
Intercomputer and peripheral device interfacing
Legacy NTDS system upgrades and integration
Compatibility & Integration Fully software-compatible with the GET NTDS family of interface adapters. NTDS cable connections are backward-compatible with previous PCI models, enabling straightforward system upgrades. Software drivers support standard operating systems for rapid deployment.
GET Engineering 10072501 — Repair & Calibration Service
Aumictech offers NIST-traceable calibration and repair for the GET Engineering 10072501. All calibrations are performed to NIST-traceable standards and ship with a certificate. Turnaround is typically 1–3 business days after receipt.
GET Engineering 10072501 price
This GET Engineering 10072501 is listed at $1,850. Calibration is available separately from $450. Contact us for volume pricing or if you need multiple units.
GET Engineering 10072501 calibration cost
NIST-traceable calibration for the GET Engineering 10072501 is $450 (standard — pass/fail certificate and calibration sticker) or $650 (full measured data at every test point, reference standards documented, traceability chain included). Turnaround is 1 to 3 business days after receipt. See full calibration details →
