Kontron CP3-SVE-P200ACG AC-DC Converter

The Kontron CP3-SVE-P200ACG is a 200 W AC-DC converter module engineered for CompactPCI systems and industrial electronic enclosures. It delivers multiple regulated output rails with hot-swap capability, current sharing across up to six parallel units, and redundant operation support. The unit accepts universal AC input (90–264 VAC, 47–63 Hz) and provides stable power in demanding temperature environments ranging from -40°C to +70°C, making it suitable for embedded applications requiring high availability and thermal resilience.

Technical Specifications Power Output

Nominal: 200 W @ 200 LFM; 250 W @ 400 LFM

+5V / 40 A

+3.3V / 40 A

+12V / 5.5 A

-12V / 1.5 A Input Specifications

Voltage: 90–264 VAC continuous

Frequency: 47–63 Hz

Inrush Current: 15 A peak (thermistor and electronic switch limited) Performance

Efficiency: 80% at full rated load, 115 VAC

Hold-up Time: 20 ms

Switching Frequency: 125–145 kHz

Operating Temperature: -40°C to +70°C (50°C without derating) Electrical Protection

All outputs: short-circuit protected with automatic recovery

Over-temperature shutdown with automatic reset

Power Fail Signal (FAL#): TTL-compatible, open collector active low; triggers when any output drops below 90% nominal or input falls below 85 VAC

Key Features

Hot-swappable design for live insertion and removal

Current sharing: ±10% accuracy across up to six parallel units on V1, V2, and V3 via single-wire tie

Redundant operation capable

Remote voltage sense on all three main rails plus sense return

47-pin Positronic male connector for direct backplane integration

Peak inrush limiting prevents supply stress during soft start

Typical Applications

3U CompactPCI chassis and subsystems

Industrial control systems requiring distributed redundant power

Telecommunications and data center infrastructure

embedded systems with extended temperature operation

Compatibility & Integration Direct integration with Kontron CompactPCI backplanes via 47-pin Positronic connector. Supports panel-mount installation in 19" rack enclosures. Multi-unit parallel configurations enable N+1 or N+M redundancy topologies with synchronized current distribution.