Anritsu 68337B Synthesized Sweep/Signal Generator, 2 – 20 GHz
Anritsu 68337B,"Synthesized sweep/signal generator covering 2 to 20 GHz, built for high-frequency testing in research and manufacturing. Delivers low-noise, high-purity signals for accurate device characterization. Offers full remote control, wide tuning range, and solid design for automated and manual signal generation tasks."
- Model
- Anritsu 68337B
- Calibration
- Available on request
- Price
- $8,279
- Status
- In stock
- RFQ ref
- 68337B
This unit
The Anritsu 68337B is a synthesized sweep and signal generator delivering high-purity signals across 2 to 20 GHz for research, development, and manufacturing test environments. It combines wide tuning range with full remote control capability, supporting both automated test setups and manual operation. The 50-ohm output impedance and low-noise architecture enable precise device characterization and system validation in demanding engineering workflows.
Technical Specifications
Signal Generation- Frequency range: 2 GHz to 20 GHz
- Output impedance: 50 Ohms
- Supports AM, FM, and pulse modulation
- Linear and logarithmic sweep modes
Key Features
- Full remote control for integrated test automation
- Synthesized architecture ensures frequency stability and precision
- Wide tuning range optimized for microwave and millimeter-wave applications
- Modulation support enables complex signal generation for device validation
- Sweep functionality streamlines frequency-dependent measurements
Typical Applications
- RF and microwave component characterization
- System-level performance validation
- Receiver and amplifier testing
- Filter and antenna measurements
- Automated production test environments
Compatibility & Integration The 68337B integrates with Anritsu test automation software and third-party control platforms via remote interfaces. Compatible with Anritsu RF power sensors, attenuators, and related test accessories. for specific accessory part numbers and interface configuration details.
Specifications
| Parameter | Value |
|---|---|
| Frequency Range | 2 GHz to 20 GHz |
Anritsu 68337B — Repair & Calibration Service
Aumictech offers NIST-traceable calibration and repair for the Anritsu 68337B. Calibration covers output frequency accuracy, output power level accuracy across the full frequency range, AM/FM/PM/pulse modulation accuracy, harmonic and spurious output levels, and phase noise floor verification. All calibrations ship with a NIST-traceable certificate. Turnaround is typically 1–3 business days after receipt.
Common Anritsu 68337B faults: YIG oscillator failure (no output or loss of lock), step attenuator wear (output drops or steps at set attenuation), ALC loop failure (uncontrolled output power), I/Q modulator assembly failure. HP/Agilent 836xx series most common faults are YIG oscillator failure and step attenuator contact wear causing output steps or drops at specific attenuation settings. Keysight E4428C/E4438C units most commonly develop ALC loop failure and I/Q modulator assembly faults. YIG oscillator replacement and attenuator service are stocked repairs.
Anritsu 68337B price
This Anritsu 68337B is listed at $8,279. Calibration is available separately from $450. Contact us for volume pricing or if you need multiple units.
Anritsu 68337B calibration cost
NIST-traceable calibration for the Anritsu 68337B is $450 (standard — pass/fail certificate and calibration sticker) or $650 (full measured data at every test point, reference standards documented, traceability chain included). Calibration for this instrument covers output frequency accuracy, output power level accuracy across the full frequency range, AM/FM/PM/pulse modulation accuracy, harmonic and spurious output levels, and phase noise floor verification. Turnaround is 1 to 3 business days after receipt. See full calibration details →
